Safety Rules & Warnings; Special Safety Information; Safety & Warnings; Safety Decal Information - Mantis 7990 Operator's & Parts Manual

Safety Rules & Warnings
You will notice throughout this Operator's Manual Safety Rules and Important Notes. Make sure you understand and obey these
warnings for your own protection.
I. SPECIAL SAFETY INFORMATION
Attention: This symbol points out our
important safety instructions.
When you see this symbol,
heed it's warning!! Stay alert!!
II. SAFETY & WARNINGS
Improper use or care of this tiller or failure to wear
proper protection can result in serious injury.
Read and understand the rules for safe
operation and all instructions in this manual.
Wear hearing and eye protection.
III. SAFETY DECAL INFORMATION
An important part of the safety system incorporated in this tiller are the warning and information decals found on various parts of
the tiller. These decals must be replaced in time due to abrasion, etc. It is your responsibility to replace these decals when they
become hard to read.
P/N 430057
P/N 400631
4
Do not reach your
fingers and\or hands
in between the tine
blades
Always remove the
outer tines before
removing the inner
tines
P/N 400635
Operator's Manual
To reduce the potential for accidents, comply
with the safety instructions in this manual.
Failure to comply may result in serious
personal injury, and/or equipment
and property damage.
The engine exhaust from this product contains
chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm.
Cutting hazard; keep Do not carry the
feet and hands away tiller in this position.
from rotating tines.
Don't operate Don't fuel, refuel,
or check fuel while
indoors
smoking, or near an
open flame or other
ignition source.
Wear ear
and eye
Protection.
Read owner's manual before
using tiller, or performing any
repair or maintenance. Keep
owners manual in a safe place.
Incorrect assembly.
Caution: when assembling
the handles, make sure
fuel tank faces away from
operator. This is the rear of
the tiller, refer to assembly
instruction on page 8-9.