Changing Needle; How To Use The Needle Holder - Janome MyLock 213 Instruction Manual

Janome ML213 Instruction Manual
1
w
q
2
e
www.aaasewing.com
8
q
w
r
t
e
w
q

Changing Needle

Turn off the power switch and unplug the machine.
Raise the needle to its highest position.
Then loosen the needle clamp screws on the right
and left to remove the needle.
Attach a new needle either on the right or left.
For regular sewing, attach the needle on the right.
For wide serging (overlocking), attach the needle on
the left.
q
Needle clamp screw on the left
w
Needle clamp screw on the right
* Use HA-1SP No.14 Needle or No.11.
To attach the needle on the right:
Insert a new needle into the needle clamp with the
flat side to the back until the top of the needle
touches the stopper pin, then tighten the needle
clamp screw on the right.
To attach the needle on the left:
Insert a new needle into the needle clamp with the
flat side to the back until the top of the needle
touches the bottom edge of the needle bar, then
tighten the needle clamp screw on the left.
Note:
Tighten the needle clamp screw on the side that is
not being used to prevent from loosing.
q
Needle clamp screw on the right
w
Needle stopper pin
e
Needle clamp screw on the left
r Bottom edge of needle bar
t
Flat side to the back
* Do not use any needle which is bent or blunt.

How to Use the Needle Holder

To attach the needle easily, use the other end of the
needle threader to hold the needle.
1. Turn off the power switch and unplug the
machine.
2. Insert a needle into the needle holder with the flat
side facing back as shown.
3. Hold the stem and insert the needle into the
needle clamp and push it up as far as it will go.
Tighten the needle clamp screw firmly while
supporting the holder in place.
4. Pull the holder down to remove it.
q
Hole
w
Flat side
e
Stem
Janome My Lock
ML213 Owners Manual/ User Guide