Changing Needle; Raising Or Lowering The Presser Foot - Janome 9102D Instruction Manual

Janome 9102D Instruction Manual
4
5
6
2
www.toews.com
16
1
2
3
4
2
1
6
1

Changing Needle

Turn off the power switch and unplug the machine.
Raise the needle to its highest position.
Then loosen the left or right needle clamp screw for the
needle you are going to remove.
1
Needle clamp screw on the left
2
Needle clamp screw on the right
Use HA-1SP #14 Needle or #11.
*
To attach the needle on the right :
Insert a new needle into the needle clamp with the
flat side to the back until the top of the needle
touches the stopper pin, then tighten the needle
clamp screw on the right.
To attach the needle on the left :
Insert a new needle into the needle clamp with the
flat side to the back until the top of the needle
touches the edge of the needle bar, then tighten the
needle clamp screw on the left.
When the needles are set correctly, the left
*
needle is higher than the right one.
Use HA-1SP #14 Needle or #11.
*
1
Needle clamp
2
Needle
3
Needle stopper pin
4
Edge of needle bar
5
Needle clamp screws
6
Flat side to the back
Do not use any needle which is bent or blunt.
*

Raising or Lowering the Presser Foot

By raising or lowering the presser foot lifter, the
presser foot goes up or down.
While in operation, keep the presser foot lowered
*
except when threading the machine or test running
without threads.
Thread tension will be released when the presser
foot lifter is raised.
1
Presser foot
2
Presser foot lifter
Janome 9102D Serger
9102D Owners Manual/ User Guide