Adjusting The Stitch Length; Changing The Needle Drop Position - Janome DC2011 Instruction Book

Adjusting the Stitch Length

Press the mode selection key
length adjusting mode.
The LED display shows "2.2" (default setting).
Press the Down (–) key to decrease stitch length.
Press the Up (+) key to increase stitch length.
The stitch length can be varied from 0.0 to 5.0.
NOTE:
The machine will not sew reverse stitches longer
than approximately 2.5 mm.

Changing the Needle Drop Position

You can change the needle drop position of straight
stitching for patterns #01–04 and #18–21
( ).
Press the mode selection key
width adjusting mode.
The LED display shows "3.5" (default setting), which
represents the center needle position.
Press the Down (–) key to move the needle to the left.
Press the Up (+) key to move the needle to the right
q Left needle position
w Center needle position
e Right needle position
to enter stitch
to enter stitch
32
1.0 2.2
0.0 3.5
q w
5.0
7.0
e