Table of Contents
Advertisement
Backup
Restore
After finishing this web page configuration, please click OK to save the settings.
3
.
5
.
4
W
P
S
3
.
5
.
4
W
P
S
Open Wireless LAN>>WPS to configure the corresponding settings.
Available settings are explained as follows:
Item
Enable WPS
WPS Configured
WPS SSID
WPS Auth Mode
WPS Encryp Type
Configure via Push
Button
Configure via Client
PinCode
Click it to store the settings (MAC addresses on MAC Address
Filter table) on this page as a file.
Click it to restore the settings (MAC addresses on MAC
Address Filter table) from an existed file.
Description
Check this box to enable WPS setting.
Display related system information for WPS. If the wireless
security (encryption) function of VigorAP 900 is properly
configured, you can see 'Yes' message here.
Display current selected SSID.
Display current authentication mode of the VigorAP 900. Only
WPA2/PSK and WPA/PSK support WPS.
Display encryption mode (None, WEP, TKIP, AES, etc.) of
VigorAP 900.
Click Start PBC to invoke Push-Button style WPS setup
procedure. VigorAP 900 will wait for WPS requests from
wireless clients about two minutes. Both ACT and 2.4G
WLAN LEDs on VigorAP 900 will blink quickly when WPS
is in progress. It will return to normal condition after two
minutes. (You need to setup WPS within two minutes)
Type the PIN code specified in wireless client you wish to
connect, and click Start PIN button. Both ACT and 2.4G
WLAN LEDs on VigorAP 900 will blink quickly when WPS
47
VigorAP 900 User's Guide
Advertisement
Table of Contents
