Advanced Image Stabilization - Canon Legria HF G25 Instruction Manual

Advanced Image Stabilization

The image stabilizer reduces camcorder blur (blur due to the camcorder moving) so you can get nice,
stable shots. Select the image stabilization mode according to the shooting conditions.
Operating modes:
1 Open the [Image Stabilizer] screen.
>
[FUNC.] [Image Stabilizer]
2 Touch the desired IS mode and then touch [X].
Options
( Default value)
[Ä Dynamic]
while walking, and is more effective as the zoom approaches full wide angle.
[Å Standard]
remaining stationary, and is suitable for shooting natural-looking scenes.
[Ì Off] Use this setting when the camcorder is mounted on a tripod.
Powered IS
After setting an assignable button to [È Powered IS] (A 85), you can use Powered IS to make
the image stabilization even more powerful. Powered IS is most effective when you are stationary
and zooming in on far subjects using high zoom ratios (the more you approach the telephoto end).
Holding the LCD panel with your left hand will add to the stability of the shot.
Operating modes:
1 Set an assignable button to [È Powered IS] (A 85).
2 Press and hold the assignable button as long as you want to activate Powered IS.
• È appears in yellow while Powered IS is activated.
• You can change the operation of the assignable button set to [È Powered IS] (long press
or toggle on/off) with the q
• Powered IS is available even when [Image Stabilizer] is set to [Ì Off].
NOTES
• If the degree of camcorder shake is too high, the image stabilizer may not be able to fully
compensate.
• For surveying and following shots, when you pan the camcorder from side to side or tilt it up and
down, we recommend setting [Image Stabilizer] to [Ä Dynamic] or [Å Standard].
Downloaded From VideoCamera-Manual.com Manuals
Compensates for a higher degree of camcorder shake, such as when shooting
Compensates for a lower degree of camcorder shake, such as when shooting while
>
[POWERED IS Button] setting.
Advanced Image Stabilization
55