Uploading Your Videos Wirelessly - Canon Legria HF G25 Instruction Manual

Uploading Recordings to the Web

Uploading your Videos Wirelessly

If you are using an Eye-Fi card, you can automatically upload movies to your favorite video sharing
Web site. You will need to have installed the software supplied with your Eye-Fi card and completed all
the required configuration setup in advance. Refer to the instruction manual of the Eye-Fi card. Also,
note that not all Eye-Fi cards can upload AVCHD movies. Check compatibility in advance.
Please read the IMPORTANT section before using an Eye-Fi card.
136
1 Insert your Eye-Fi card into memory card slot 3 and make sure there is sufficient
available space on the memory card.
2 Set the camcorder to
• To upload movies (AVCHD): Scenes that were recorded on (or copied onto) memory card 3
will be automatically uploaded to the Web if you are within range of a configured network.
• To upload SD movies: Convert the desired scenes (A 133). At the end of the procedure, touch
[End Without Connecting]. The converted SD movies on memory card 3 will be automatically
uploaded to the Web if you are within range of a configured network.
• The status of the wireless communication is shown by the Eye-Fi icon as follows:
- • (grayed out) Communication not established
- • (white, flashing) Connecting; • (white, continuously on) Wireless upload on standby
- • (animated) Wireless upload in progress
- ... q
- ‰ Wireless upload stopped by the camcorder (A 158)
- ‹ Error reading from the Eye-Fi card (A 157)
IMPORTANT
Using an Eye-Fi Card
• This product is not guaranteed to support Eye-Fi card functions (including wireless transfer). In case
of an issue with an Eye-Fi card, please check with the card manufacturer. Also note that an approval
is required to use Eye-Fi cards in many countries or regions. Without approval, use of the card is not
permitted. If it is unclear whether the card has been approved for use in the area, please check with
the card manufacturer.
• Do not use Eye-Fi cards on airplanes and in other places where wireless communication is
forbidden. Remove the Eye-Fi card from the camcorder beforehand.
NOTES
• Depending on the amount of data to be uploaded and the network's wireless connection
conditions, it can take some time to upload video files. If the wireless connection is too weak, the
wireless upload may fail and the video files will be registered as incomplete uploads.
• About power saving:
- Wireless communication drains the power of the battery pack faster than usual. We recommend
powering the camcorder using the compact power adapter.
- While files are being uploaded wirelessly, the camcorder's automatic power off function will be
disabled.
• Wirelessly uploading files is not possible when the Eye-Fi card is in memory card slot 2 (the Eye-Fi
icon will not appear on the screen). Be sure to insert the Eye-Fi card into memory card slot 3.
• While using an Eye-Fi Card, the ACCESS indicator may flash from time to time.
• Wireless communication is available only in playback mode. Any wireless transfer in progress will be
stopped if you set the camcorder to recording mode.
Downloaded From VideoCamera-Manual.com Manuals
mode.
>
[Eye-Fi Communication] is set to [j Off]