Table of Contents
Advertisement
Reasons for dirty glass
· Fuel too wet
· Logs too large or not split
· Combustion temperatures too low
Replace broken glass immediately.
Do not operate your stove if the glass in the door is damaged.
If you need to replace the glass, it should be replaced with the high temperature ceramic class
supplied by Morsø, contact your Morsø dealer.
Installing the glass
Never install the glass when the stove is in function.
. Lift the door off its hinges an place face-down on a sheet of cardboards or other non-
abrasieve fabric.
. Unscrew the eight bolts that secure the glass. (In the event that a bolt sheers off when
being unscrewed, remove the remaining body of the bolt by drilling down its cnetre with
/8 inch high speed steel drill bit. Smaller drill bits may be successful, but do not use a
lager bit. Make sure the bit stays away from the edges of the bolt - this may damage the
thread in the cast iron).
3. Remove the old ceramic gaskets and clean up the surface underneath with wire wool or
emery paper to remove loose particles.
4. Place the new gasket material in position around the perimeter of the window area,
making sure to pinch them to the length in such a way that they make a continuous seal.
Leave no gaps.
5. Place the new glass in position on the strips and screw home the fresh bolts and fitting
by hand.
7
Hide quick links:
Advertisement
Table of Contents
