Coolant Level Check; Coolant Replacement - Husqvarna 2013 CR 125 Owner's Manual

COOLANT LEVEL CHECK

Check level (1) in right-hand radiator when engine is cold (place
the motorcycle so that it is perpendicular to the ground). The
coolant should be approximately 0.39 in. above the cells.
The radiator cap features two locking positions: the first one is
for prior discharge of pressure from the cooling system.
WARNING
Avoid removing radiator cap when engine
is hot, as coolant may spout out and cause
scalding.
NOTE
Difficulties may arise in eliminating coolant
from varnished surfaces. If this occurs, wash
off with water.
1
2

COOLANT REPLACEMENT

- Place the vehicle on a flat ground and in horizontal position.
- Place a vessel of adequate capacity on the right side of the
vehicle under the water pump (1).
- Loosen the exhaust screw (2) using an 8 mm wrench.
- Slowly open the RH radiator cap (3) and let the liquid drain.
- After drain, tighten the screw (2) replacing the aluminium
sealing washer.
WARNING*: Avoid removing radiator cap
when engine is hot, as coolant may spout out
and cause scalding.
WARNING:
Difficulties may arise in eliminating coolant
from painted surfaces. If this occurs, wash off
with water.
- pour the necessary quantity of liquid in the radiator;
- warm up the motor in order to eliminate any possible air bub-
ble;
- fit the motor in vertical position and check that the liquid in
the radiators must be 10 mm/0.4 in. over the radiant mas (if
not, top it up);
10 mm
(0,39 in.) - screw the R.H. radiator plug.
WARNING*: Coolant on tires will make them
slippery and can cause an accident or injury.
Periodically check the connecting hoses (see "Periodical mainte-
nance card"): this will avoid coolant leakages and consequent
engine seizure: If hoses show cracks, swelling or hardenings due
to sheats desiccation, their
replacement shall be advisable. Check the correct tightening of
the clamps.
SPECIFICATIONS - OPERATION - MAINTENANCE
1
2
3
EN - 21