Engine Start - Husqvarna 2013 CR 125 Owner's Manual

ENGINE START

For the correct start of a cold engine proceed as follows:
- shift the transmission into neutral;
CR - WR USA:
- open cock (1), by loosening ring nut (2);
WR:
- set fuel valve (3) in ON position;
- lift the knob lever (4) on the carburetor.
Leaving the throttle in closed position operate kick-start (5).
Take the knob lever in its initial position as soon as the engine
is idling.
When starting with an already warmed up engine DO NOT USE
the starter. You can start the engine with the gear inserted, after
disconnecting of the clutch.
If the carburetor is flooded, shut off the fuel supply and the
starter and operate the crank lever or the kick-start until the
engine starts. If necessary, remove the spark plug and dry it.
N
EN - 18 SPECIFICATIONS - OPERATION - MAINTENANCE
IMPORTANT NOTE IN CASE OF COLD STARTS AT
LOW TEMPERATURES
It is recommended to briefly warm-up the en-
gine at idle until, after having disengaged
the starter, there is a normal response from
the engine when opening the throttle.
This will enable the lubricant to reach the cor-
rect working temperature thereby guarantee-
ing a correct functioning of all engine parts.
Avoid overheating the engine.
IMPORTANT
Never accelerate the engine after a cold start.
WARNING*: Exhaust contains poisonous car-
bon monoxide gas. Never run the engine in a
closed garage or in a confined area.
WARNING*: This high performance motor-
cycle can some times «kick back» strongly
when you are starting it.
Do not attempt to start this motorcycle unless
you are wearing high top heavy sided rid-
ing boots. You could seriously hurt you leg
if the kickstarter kicked back and your foot
slipped.
CR - WR USA
1
2
5
4
WR
ON
3