Getting started
Battery installation and charging
Install the battery, as shown below. The battery needs charging when it is
newly installed into the wireless mic, or the status indicator on the wireless
mic flashes orange. For best performance, keep the wireless mics on the
charging cradles when not in use. The battery is fully charged after eight
hours of continuous charging.
The status indicator on the wireless mic turns orange when charging, and
turns off when the battery is fully charged.
1. Place the battery with the label THIS SIDE UP facing up onto the battery
compartment. The status indicator flashes orange once in three seconds.
2. Slide the battery door until it clicks into place.
3. Place the wireless mics on the charging cradles until they are flush.
IMPORTANT INFORMATION
1. Use only the supplied rechargeable battery or replacement battery (model BT191665).
To order, visit our website at
1 (800) 222-3111
2. If you do not use the wireless mics for a long time, disconnect and remove the battery
to prevent possible leakage.
www.smbtelephones.att.com
1 (866) 288-4268
. In Canada, dial
9
or call
.