Error And Maintenance Messages - Brother DCP-9042CDN User Manual

Error and maintenance messages

As with any sophisticated office product, error and maintenance messages may be displayed. The
most common error and maintenance messages are shown below.
Error Message Cause
Calibration failed.
Calibrate
The toner cartridge is not installed
Cartridge Error
properly.
Put the Black (K)
Toner Cartridge
1
back in.
1
The toner cartridge
colour with the
problem is shown
in the message.
Change Belt Unit It is time to replace the belt unit.
It is time to replace the paper
Change PF Kit
feeding kit for the MP tray.
MP
Change PF Kit 1 It is time to replace the paper
feeding kit for Tray 1.
The temperature of the drum unit
Cooling Down
or toner cartridge is too hot. The
Wait for a while
machine will pause its current
print job and go into cooling down
mode. During the cooling down
mode, you will hear the cooling
fan running while the LCD shows
Cooling Down, and
Wait for a while.
62
Action
Press Mono Start/Colour Start and try it again.
Do one of the following:
Turn off the machine's power switch. Wait a
few seconds, then turn it on again.
Put in a new drum unit. (See Replacing the
drum unit on page 102.)
Put in a new belt unit. (See Replacing the
belt unit on page 108.)
Put in a new waste toner box. (See Replacing
the waste toner box on page 113.)
If the problem continues, call your Brother
dealer.
Pull out the drum unit, take out the toner
cartridge that is indicated on the LCD, and put it
back into the drum unit again.
Replace the belt unit. (See Replacing the belt
unit on page 108.)
Call your Brother dealer to purchase a new
PF Kit MP.
Call your Brother dealer to purchase a new
PF Kit 1.
Make sure that you can hear the fan in the
machine spinning and that the exhaust outlet
isn't blocked.
If the fan is spinning, remove any obstacles that
surround the exhaust outlet, and then leave the
machine turned on but do not use it for several
minutes.
If the fan is not spinning follow the suggestions
below.
Turn off the machine's power switch and then
turn it on again. If the error message continues
leave the machine for several minutes and then
try it again.
C