NETGEAR Nighthawk D7000 User Manual page 77

Nighthawk AC1900 WiFi VDSL/ADSL Modem Router Model D7000
Field
VCI
Use VLANID
Priority (0 ~ 7)
Bridge Mode
Account Name
Domain Name
Internet IP Address or IPTV IP Address (depending on your selection in Step 8)
Get Dynamically from ISP
Use Static IP Address
Description
these settings are not disabled. However, these settings do not
apply to a cable or fiber connection and you can ignore them.
Select the Use VLANID check box and enter the VLAN ID, as
indicated by your ISP.
A VLAN ID might be required if you subscribe to both Internet
service and IPTV service. If your ISP did not provide you with a
VLAN ID, leave the Use VLANID check box cleared, which is the
default setting.
If your ISP provided you with a VLAN ID and a priority value,
enter the priority value, which is a number from 0 to 7.
You can enter a priority value only in combination with a VLAN
ID. If your ISP did not provide you with a priority value, leave the
default setting (0).
This setting is an option that applies to the IPTV interface only.
For information about configuring bridge mode, see
Mode for IPTV Devices
Enter the account name, as indicated by your ISP. This name
might also be called the host name.
If your ISP did not provide you with an account name or host
name, leave the default setting.
Enter the domain name, as indicated by your ISP.
If your ISP did not provide you with a domain name, leave this
field blank.
Your ISP uses DHCP to assign your IP address. Your ISP
automatically assigns these addresses.
Enter the IP address, IP subnet mask, and gateway IP address
that your ISP assigned you for static IP address service. The
gateway is the ISP router to which your modem router connects.
Manage the Internet Settings Manually
77
on page 215.
Enable Bridge