Table of Contents
Advertisement
MANTELS
When the fireplace is being installed into a woodburning
fireplace the minimum the mantel can be above the fire-
place is governed by local building codes applicable to
woodburning fireplaces. Consult local authorities having
jurisdiction for these clearances.
The underside of the mantel will get quite
warm.
Use only finishes which are heat
resistant and do not discolour.
The fitting of the bay window kit does not
affect the dimensions or reference points in
the mantel chart.
MANTEL CHART
Ref.
Mantel & Leg
Ref.
Shelf Depth
V
10" (254 mm) A
W
8" (203 mm)
B
X
6" (152 mm)
C
Y
4" (101 mm)
D
Z
2" ( 51 mm)
E
A
B
C
D
E
FIREBOX TOP
FRONT
GLASS
OPTIONAL
HEARTH
RAISED
Mantel From
Mantel Leg from
Top of Comb. From Side of Comb.
Chamber
Chamber
19" (305 mm)
10" (254mm)
17" (254 mm)
8" (203mm)
15" (203 mm)
6" (152mm)
13" (152 mm)
4" (101mm)
11" (101 mm)
2" (51mm)
V
W
X
WALL
Y
Z
TOP
LOUVRE
OPENING
FIREPLACE
SIDE VIEW
Before deciding on the frame dimensions and finishing
materials it is important to consider the finished dimensions
of the chosen fireplace trim kit (see options section of this
manual).
This information is required at this stage to ensure a
satisfactory finish when the trim kit is installed.
The use of wall paper adjacent to this fireplace
CLEARANCE TO COMBUSTIBLES
Fig. 2
Non-combustible materials such as brick and tile can be
extended over the face of the unit (Do not cover louvres
or glass door). If a Trim Kit is going to be installed, brick
and tile will have to be installed flush with the side of this
appliance.
A hearth is not mandatory but it is recommended for
aesthetic purposes. We recommend a non-combustible
hearth which does not obstruct louvre opening.
Fig. 3
- 5 -
FRAMING & FINISHING
is not recommended, as the high heat given off
by this fireplace may adversely effect the bind-
ers in the adhesive used to apply the wallpa-
per.
Sides ....... 0 mm/0 inches
Sides ....... 0mm/0 inches
Floor ........ 0 mm/0 inches
Top .......... 0 mm/0 inches
FINAL FINISHING
HEARTH
Cold climate installation recommendation:
When installing this unit against a non-
insulated exterior wall or chase, it is
mandatory that the outer walls be insulated
to conform to applicable insulation codes.
Hide quick links:
Advertisement
Table of Contents
