Start-Up Guide - Sony KDL-52Z4500 Operating Instructions Manual

Start-up Guide

1: Checking the accessories
AC power cord (1)
Antenna cable (1)
Stand (1) and screws (4) (KDL-46Z4500/40Z4500
only)
Remote RM-GD005 (1)
Size AA batteries (R6 type) (2)
To insert batteries into the remote
Push and lift the cover to open.
~
• Observe the correct polarity when inserting
batteries.
• Do not use different types of batteries together or
mix old and new batteries.
• Dispose of batteries in an environmentally
friendly way. Certain regions may regulate the
disposal of batteries. Please consult your local
authority.
• Handle the remote with care. Do not drop or step
on it, or spill liquid of any kind onto it.
• Do not place the remote in a location near a heat
source, a place subject to direct sunlight, or a
damp room.
To replace the speaker grille
The speaker grille unit can be replaced with
others that are sold separately. However, do
not remove the unit except to replace it. For
details, see the instructions supplied with
speaker grille units.
4
GB
2: Attaching the stand (for
KDL-46Z4500/40Z4500)
1
Place the TV onto the stand by aligning
the screw hole alignment lines over the
stand as shown.
2
Fix the TV to the stand according to the
arrow marks that guide the screw holes
using the supplied screws.
~
• This TV is very heavy, so two or more people
should place the TV on the stand.
• If using an electric screwdriver, set the tightening
torque at approximately 1.5N·m (15kgf·cm).
• When installing the TV onto the wall, follow step
1 to prevent the TV panel from falling over.