Table of Contents
Advertisement
Start-up Guide
Checking the
accessories
Stand (1) and screws (3)
Remote RM-GA011 (1)
Size AA batteries (R6 type) (2)
Inserting batteries into
the remote
Push and lift the cover to open.
• Observe the correct polarity when inserting
batteries.
• Do not use different types of batteries together or
mix old and new batteries.
• Dispose of batteries in an environmentally
friendly way. Certain regions may regulate the
disposal of batteries. Please consult your local
authority.
• Handle the remote with care. Do not drop or step
on it, or spill liquid of any kind onto it.
• Do not place the remote in a location near a heat
source, a place subject to direct sunlight, or a
damp room.
4
GB
1: Attaching the stand
1
Place the TV onto the stand by aligning the
screw hole alignment lines over the stand
as shown.
2
Fix the TV to the stand according to the
arrow marks
that guide the screw holes
using the supplied screws.
• This TV is very heavy, so two or more people
should place the TV on the stand.
• If using an electric screwdriver, set the tightening
torque at approximately 1.5N·m (15kgf·cm).
• When installing the TV onto the wall, follow step
1 to prevent the TV panel from falling over.
• Ensure the AC power cord is away from screw
holes during stand installation to avoid damage to
the AC power cord.
Advertisement
Table of Contents
