FOllOw inStructiOnS MaY reSult in PrOPertY daMage, bOdilY injurY, Or eVen death. FOr uSe in the u.S. and canada. Suitable FOr inStallatiOn in MObile hOMeS. iF thiS harMan StOVe iS nOt PrOPerlY inStalled, a hOuSe Fire MaY reSult. FOr YOur SaFetY, FOllOw inStallatiOn directiOnS.
Page 3
Damp pellet as a result of using fuel with higher ash or mineral fuel could turn back into sawdust which does not flow content. properly through the feed system. XXV Pellet Stove...
Page 4
8”/20cm Back (B) 0” 0” Front (C)* 6”/15cm 18”/46cm *Measured from window opening. PROTECTION DU PLANCHER: CANADA (A)* 6” /15cm 8”/20cm 0” 0” (C)* 6”/15cm 18”/46cm Harman Home Heating- 352 Mountain House Road - Halifax, PA 17032 XXV Pellet Stove...
A new concept for the XXV is the ability to use the top vent option. Using this method, the XXV can easily replace a wood stove by placing the top vent adapter over the rear vent.
Or SYSteM. not be placed on or near this unit. installation and repair of this harman stove should be done by a qualified service person. we recommend that the stove be inspected before use and at least annually by a qualified service person.
MObile hOMe FlOOr, wall, and ceiling/ flue vent to rOOF MuSt be Maintained. wall warning Mobile home regulations do not allow installation in a room designated for sleeping. Fig. 5: Optional Top Vent Pipe Clearances XXV Pellet Stove...
J. The clearance to a non-mechanical air supply inlet NOTE: Only the Harman Direct Vent Wall Pass-through to the building or the combustion air inlet to any other (part # 1-00-677077) or PL listed vent pipe wall pass- appliance must be a minimum of 48”.
Page 9
However, in some cases a perfect seal is not achieved. For this reason and the fact that the XXV operates with a positive vent pressure we specify that the joints also be sealed with silicone. Aluminum tape can also be used for any joint that is 1 ft.
1-00-08543 (25') these conditions. Outside air: harman home heating and hearth & home tech- nologies strongly recommend attaching outside air Inlet Cover part# in all installations, especially lower level and main 1-10-08542 Fig.
Page 11
3 ft. elevated exhaust temperatures at least 3 feet to combustibles away from the flue termination. 12" min. wall to outlet Fig. 11 3 ft. Fig. 10 to combustibles XXV Pellet Stove...
Page 12
A chimney. This method will be desirable for people who are replacing a wood or coal stove and have an existing chimney to use. 6" from pipe to wall Fig. 13 XXV Pellet Stove...
Page 13
In this method a 4 inch liner is installed the entire length of the flue. Whether using a rigid or flexible liner, a cap should be installed on the chimney to keep out rain. Fig. 15 XXV Pellet Stove...
Page 14
3" of the PL vent pipe. warning: the chiMneY MuSt be OF a tYPe Suitable FOr SOlid Fuel burning. the chiMneY and 3" min. chiMneY cOnnectOr MuSt be kePt clean and Maintained in gOOd cOnditiOn. Fig. 17 XXV Pellet Stove...
& home technologies assumes no responsibility for, nor does the warranty extend to, smoke damage caused by reverse drafting of pellet appliances under shut-down or power failure conditions. XXV Pellet Stove...
For dealer maintenance Allows you to adjust the only. Requires special DDM room temperature in monitor supplied to Harman Room Temp Mode using Dealers exclusively. the outer scale marked D i s t r i b u t i o n B l o w e r in degrees Fahrenheit.
Neither pellets or a fire are required for this test. and igniter operation. The XXV is then factory set at a 3. With the mode selector in the "OFF" position, turn mid-point adjustment and in most cases will not need any the feed adjuster to "TEST".
The XXV is a fully automatic stove that features two room temperature Mode operating modes; Stove temperature Mode and room temperature Mode. In Stove Temperature Mode, you select a burn rate and the stove will remain at the same burn rate regardless of the room temperature.
Page 19
If this happens simply reset the control board by turning the mode selector to OFF and back ON. This setting, see above, will produce continuous maximum heat output with the distribution blower at full speed. Fig. 21 XXV Pellet Stove...
Page 20
The 1" ash bed is only a maximum burn rate and at most normal settings the ash bed will be larger. OnlY uSe wOOd Pellet Fuel. dO nOt burn garbage in StOVe. XXV Pellet Stove...
Manual ignitiOn/OPeratiOn The XXV Pellet Stove is capable of manual operation. This also allows the opera- tor to manually control operation during an emergency (i.e. igniter failure, or when using certain generators.) The unit can be switched between "AUTO" and "MANUAL" at any time during operation.
Page 22
The 1" ash bed OnlY uSe the SPeciFied FuelS. dO nOt burn is only a maximum burn rate and at most normal settings the ash garbage in StOVe. bed will be larger. XXV Pellet Stove...
NOTE: Distances of more than 25 feet from the unit or in another room are not recommended. The room sensor is essential for the XXV's excellent efficiency. NOTE: it is recommended that the room sen- sor be installed, even if only installed on the rear of the unit as a return air sensor.
Inspect the holes on the burn pot surface. See Fig. 35. 5. Open the burn pot clean-out. Clean fly ash from the burn pot and replace the cover. See Figures Fig. 35 39 and 40 on page 26. XXV Pellet Stove...
Page 25
The stove should be cleaned after each ton cleaning with of pellets (50 bags) and the venting system inspected brush. and cleaned after each heating season. Fig. 38 XXV Pellet Stove...
(3 mm Burn pot igniter or more), it should be removed to reduce the risk of a chimney or venting system fire. Viewed from below through the ash pan opening. Fig. 41 XXV Pellet Stove...
Page 27
Fig. 43 Pellet Fines will build up in this area Viewing glass The glass in your Harman stove is a special ceramic glass. • Do not abuse the glass by striking or slamming the door. • Never burn the appliance if the door glass is cracked or broken.
Vent wall Passthrough The Harman Direct Vent Wall Passthrough makes harman Part #1-00-677077 installing your Harman Pellet Stove with outside air a lot easier. It is made to fit walls from 4 1/2" up to Outdoor Half 10 1/8" thick with a square opening of 6" to 6 1/2".
3% or more. ash or carbon buildup. The XXV is capable of burning all 3 categories of pel- 5. Combustion blower fan blades may need lets or a mixture of up to 50% shelled corn and pellets.
3 inch or optional 6" top exit Outside air Size 2 3/8" i.d. inch Fuse rating 6 amp wiring diagram HARMAN ACCENTRA & XXV PELLET STOVE WIRING DIAGRAM MALE/FEMALE CONNECTIONS BROWN WHITE GREEN WIRE IS GROUND REMOTE SENSOR PORTS 6 AMP GLASS FUSE...
Contact your dealer if you have questions about UPS compatibility with your appliance. harman Surefire 512h battery back-up The 512H connects to a 12 volt deep cycle battery that will run your appliance for up to eight (8) hours. It includes a trickle charge feature that keeps your battery charged when power is available.
Hearth & Home Technologies Inc. LIMITED LIFETIME WARRANTY Hearth & Home Technologies Inc., on behalf of its hearth brands (”HHT”), extends the following warranty for HHT gas, wood, pellet, coal and electric hearth appliances that are purchased from an HHT authorized dealer. WARRANTY COVERAGE: HHT warrants to the original owner of the HHT appliance at the site of installation, and to any transferee taking ownership of the appliance at the site of installation within two years following the date of original purchase, that the HHT appliance...
Page 33
WARRANTY CONDITIONS: • This warranty only covers HHT appliances that are purchased through an HHT authorized dealer or distributor. A list of HHT authorized dealers is available on the HHT branded websites. • This warranty is only valid while the HHT appliance remains at the site of original installation. •...
Addendum for Burning Corn and Pellet Fuel Mixture Harman pellet burning, free-standing stoves and inserts have been tested to ASTM E1509 for burning shelled corn in a mixture with wood pellets. The listing approves up to a 50% corn and 50% pellet mixture. Different mixtures of corn will have distinctively different burn characteristics depending upon moisture content and variety.
Page 36
XXV Pellet Stove Service Parts beginning Manufacturing date: n/a ending Manufacturing date: active IMPORTANT: THIS IS DATED INFORMATION. When requesting service or replacement Stocked parts for your appliance please provide model number and serial number. All parts listed in this manual may be ordered from an authorized dealer.
Page 37
XXV Pellet Stove Service Parts beginning Manufacturing date: n/a ending Manufacturing date: active IMPORTANT: THIS IS DATED INFORMATION. When requesting service or replacement Stocked parts for your appliance please provide model number and serial number. All parts listed in this manual may be ordered from an authorized dealer.
Page 38
XXV Pellet Stove Service Parts beginning Manufacturing date: n/a ending Manufacturing date: active #39 Pre Serial number 12826 Feeder assembly 39.1 39.2 39.13 39.3 39.4 39.12 39.11 39.10 39.9 39.7 39.6 39.5 39.8 IMPORTANT: THIS IS DATED INFORMATION. When requesting service or replacement Stocked parts for your appliance please provide model number and serial number.
Page 39
XXV Pellet Stove Service Parts beginning Manufacturing date: n/a ending Manufacturing date: active #40 Post Serial number 12826 Feeder assembly 40.1 40.15 40.12 40.16 40.14 40.2 40.13 40.3 40.11 40.10 40.9 40.4 40.5 40.8 40.7 40.6 IMPORTANT: THIS IS DATED INFORMATION. When requesting service or replacement Stocked parts for your appliance please provide model number and serial number.
Page 40
XXV Pellet Stove Service Parts beginning Manufacturing date: n/a ending Manufacturing date: active IMPORTANT: THIS IS DATED INFORMATION. When requesting service or replacement Stocked parts for your appliance please provide model number and serial number. All parts listed in this manual may be ordered from an authorized dealer.
Page 41
Service & Maintenance log date Of Service Performed by description Of Service XXV Pellet Stove...
Page 42
Service & Maintenance log date Of Service Performed by description Of Service XXV Pellet Stove...
Need help?
Do you have a question about the XXV and is the answer not in the manual?
Questions and answers