Brother MFC-J3520 User Manual page 73

a
Open the media slot cover.
b
Put the memory card or USB Flash drive
in the correct slot.
c
Press Scan to Media.
d
Load your document.
e
Press Options.
f
Press a or b to display Auto Crop.
g
Press Auto Crop.
h
Press On.
i
Press OK.
j
If you do not want to change additional
settings, press Start to start scanning.
k
The number of the scanned documents
appears on the Touchscreen.
Press OK to confirm.
l
Press d or c to preview the data for each
document.
m
Press Save All to save the data.
Printing photos from a memory card or USB Flash drive
NOTE
• Auto Crop is available for paper with
90-degree angles at all four corners. If one
of the angles is not square, Auto Crop
cannot detect the document.
• If your document is too long or wide, this
setting does not work correctly. The
document has to meet the following
specification: up to 195  270 mm.
If the ratio between the height and width of
the document is more than 1 to 8, this
setting does not work correctly.
• You must place the documents away from
the edges of the scanner glass as shown
in the illustration.
• You must place the documents at least
10 mm apart from each other.
• Auto Crop adjusts the skew of the
document on the scanner glass, but if your
document is skewed more than
10 degrees, this setting will not work.
• The ADF must be empty to use
Auto Crop.
• The Auto Crop feature is available for up
to a maximum of 32 documents,
depending on the documents' sizes.
• ADF High Speed Mode and
Scan Long Paper are not available with
Auto Crop.
IMPORTANT
DO NOT take out the memory card or
USB Flash drive while the machine is
reading or writing to the memory card or
USB Flash drive to avoid damaging the
card, USB Flash drive, or the data stored
on them.
8
67