Remote Fax commands
Follow the commands in the table to access features when you are away from the machine. When
you call the machine and enter your Remote Access Code (3 digits followed by ), the system will
give two short beeps and you must enter a remote command.
Change the Fax Forwarding or Fax
2 Fax Forwarding
4 Fax Forwarding number
6 Fax Storage
Retrieve a fax
2 Retrieve all faxes
3 Erase faxes from the memory
Check the receiving status
Change the Receive Mode
1 External TAD
3 Fax Only
You can choose Off after you have retrieved or erased all
One long beep means the change is accepted. If you hear
three short beeps, the change was not accepted because
something has not been set up (for example, a Fax
Forwarding number has not been registered). You can
register your Fax Forwarding number by entering 4. (See
Changing your Fax Forwarding number on page 26.) Once
you have registered the number, Fax Forwarding will work.
Enter the number of a remote fax machine to receive stored
fax messages. (See Retrieving fax messages on page 26.)
If you hear one long beep, fax messages have been erased
from the memory.
You can check whether your machine has received any
faxes. If yes, you will hear one long beep. If no, you will hear
three short beeps.
If you hear one long beep, your change has been accepted.
Pressing 9 0 allows you to exit Remote Retrieval. Wait for
the long beep, then replace the handset.
Receiving a fax