Table of Contents
Advertisement
Location and
Functions of Parts
and Controls
Camera
Front
1
2
3
A Lens
This is a 30-magnification optical zoom
lens.
B Infrared remote commander
sensors
These are sensors for the supplied
infrared remote commander.
C POWER lamp
The green lamp lights when the camera
is connected to an AC outlet using the
supplied AC power adaptor and AC
power cord. It takes about 15 to
30 seconds to display the image after the
lamp lights.
The green lamp flashes when the camera
receives an operation command from the
supplied infrared remote commander.
8
Location and Functions of Parts and Controls
4
2
D STANDBY lamp
The orange lamp lights when the camera
is turned off using the infrared remote
commander.
Rear
E Infrared remote commander
sensors
These are sensors for the supplied
infrared remote commander.
F IMAGE FLIP switch
Flips the image upside down. Normally
set this to OFF when you use the camera.
When the camera is attached to the
ceiling, set this to ON. Turn off the unit
before setting the IMAGE FLIP switch.
Then, turn the power on by connecting
the power adaptor, by VISCA
CONTROL or the infrared remote
commander. When you switch this, the
preset setting is returned to the initial
setting.
G VISCA RS-422 connector
To communicate via RS-422, use this
connector.
Hide quick links:
Advertisement
Table of Contents
