Lan Connection; Connecting The Rm-Ip10 Ip Remote Controller - Sony SRG-300H Operating Instructions Manual

• It is not possible to connect both VISCA
RS-232 and VISCA RS-422
simultaneously.
• Do not mix VISCA RS-232 (cross) and
VISCA RS-422 cables. Using these cables
at the same time may result in
malfunction. Cannot be used in the LAN
connection.

LAN connection

SRG-300H
Computer
Notes
• In the case of a LAN connection, make
sure that the BOTTOM switch of the
camera is set for LAN connection
(page 10).
• Dedicated application software is needed.
For details about the application software,
consult your Sony dealer.
34
Connections
• Use a LAN cable that is compatible with
Use the RS-232 connecting cable supplied
with the IP remote controller.
to the AC power
adaptor
(supplied)
LAN cable
(not supplied)
RM-IP10 IP
Remote Controller
Note
When using the VISCA RS-232 connectors,
check that the BOTTOM switch on the
bottom of the camera (page 10) and the
BOTTOM switch on the bottom of the IP
remote controller are set to RS-232.
10BASE-T/100BASE-TX (category 5 or
higher, shielded twisted pair) for this
connection.
Connecting the RM-IP10 IP
Remote Controller
SRG-300H
VISCA
RS-232
IN
VISCA RS-232
MODE LAN RS-232C
VIS CA
1
DC IN 12V
to the AC
power
adaptor
(supplied)
RS-232 cable
(supplied with
the RM-IP10)
!
RS-422 TAL LY/CONTACT
9 1 9
DC 12V
to the AC power
adaptor (supplied
with the RM-IP10)