Table of Contents
Advertisement
Message
RESET n: OK
You have reset the
"n" is a preset
camera settings stored
position number of
in POSITION 1 to 6 to
the infrared remote
the default settings.
commander,
between 1 and 6.
ONE PUSH WB:
During the white
OP
balance adjustment in
the ONE PUSH white
balance mode, the
message blinks on the
screen.
ONE PUSH WB:
When white balance
OK
adjustment is correctly
performed in ONE
PUSH white balance
mode, this message
appears on the screen.
ONE PUSH WB:
If white balance
NG
adjustment is
incorrectly performed
in ONE PUSH white
balance mode, this
message flashes on the
screen.
Note
The operations in the VISCA CONTROL
and LAN connection are from n: 1 to 16.
VIDEO MODE
The setting of the HDMI and DVI are
available when the video is output from the
HDMI video connector.
When the SYSTEM SELECT is set to
EDID, the video mode cannot be set.
COLOR SYSTEM
The setting of the YCbCr and RGB are
available for color space of the video image.
When the SYSTEM SELECT is set to
EDID, the color system cannot be set.
Remote control
operation
STATUS Menu
The STATUS menu is used to display the
settings selected with the menus.
The STATUS menu consists of PAGE1 to
PAGE5.
This menu only displays the current menu
settings, and you cannot change them with
this menu.
PAGE1: Shows the settings selected with
the EXPOSURE menu.
PAGE2: Shows the settings selected with
the PICTURE menu and the WHITE
BALANCE menu.
PAGE3: Shows the settings selected with
the PAN TILT ZOOM menu.
PAGE4: Shows the settings selected with
the SYSTEM menu, supplied infrared
remote commander channel, VISCA
communication baud rate, VIDEO
mode, Color system and Video latency
setting.
PAGE5: Shows the settings selected with
the LAN connection with IP address,
Subnet mask and MAC address (shows
when the BOTTOM switch is set to
LAN only).
Note
The VISCA communication baud rate and
the VIDEO mode for the camera are
displayed. Even if you change the settings
after turning on the power, those settings are
ignored and are not changed on the display.
For detailed information on the Video
latency setting, refer to the Technical
Manual of the camera.
21
STATUS Menu
Hide quick links:
Advertisement
Table of Contents
