Table of Contents
Advertisement
h
& c
eating
ooling
clockwise all the way to turn on the heater. When the room reaches the desired temperature,
turn the thermostat knob counter-clockwise until you hear a "click". Leave in this position to
maintain the room temperature at this setting. For additional heat, turn clockwise until you
hear the "click" again and the heater will turn on.
Resetting the Temperature Cutoff Switch:
Should the heater overheat, an automatic cut out will turn the heater off and it will not come
back on without being reset. It can be reset by switching the 3 Position Switch "A" to OFF
(center position) and waiting 5 minutes before switching the unit back on again.
If you need to continuously reset the heater, unplug the unit and call technical
support at 1-888-346-7539.
Remote Operation:
The fireplace is supplied with an integrated ON/OFF remote control. The 3 Position Switch
"A" must be set to the remote control setting "II". To operate, push the ON button on the
remote, to turn on the fireplace. Press the OFF button on the remote to turn off the fireplace.
NOTE: Before attempting any operation with the remote control,
pull the plastic insulator strip out from between the remote control
casing and the battery cover. .
Remote Control Initialization/Reprogram:
In the event that your remote control ceases to operate the fireplace, follow these steps to
reinitialize the remote control and the remote control receiver in the fireplace:
1.
Place the 3 Position Switch "A" in the center (OFF) position. Wait a minimum of 5
seconds and then place Switch "A" in the "II" position (for Remote Control).
2.
Within 10 seconds of changing the switch position, press the ON button located on the
remote control. This will synchronize the remote control with the fireplace receiver.
NOTE: You only have 10 seconds to perform Step 3. Failure to do
so results in having to perform Steps 1 to 3 a second time..
Battery Replacement:
1.
Slide the battery cover open on the remote control. (Correctly install one 12 volt A23
type battery in the battery holder.
2.
Close the battery cover.
124
Advertisement
Table of Contents
