Table of Contents
Advertisement
4.
Place the end of the sewer hose into the approved dump station.
5.
Open the black tank dump valve. (Valve may be located under the RV, or on the Utility
Center if so equipped) Close the dump valve when the black water holding tank is
emptied.
6.
Open the grey tank dump valve. (Valve may be located under the RV, or on the Utility
Center if so equipped) Close the dump valve when the grey holding tank is emptied.
7.
Remove, clean and store the sewer hose.
8.
Close the sewer hose housing dust cap.
You can locate many dump stations throughout the United States and Canada in Woodall's,
Rand McNally Camp Guide, Good Sam Camp Guide, KOA Kampgrounds Camp Guide and
various other publications. Some fuel stations also have dump stations.
Please contact your RV dealer for assistance in the purchase and installation of a sewer hose
or sewer hose extension (if needed).
Sewage (black) tank preparation:
It is important to add enough water to prevent solid waste buildup. Follow the
directions listed below and in the manufacturer's operator manual.
1.
Release one to two quarts (1 or 2 liters) of water into the toilet bowl.
2.
Follow the directions on your (RV approved) toilet chemical bottle (customer supplied),
by placing the recommended quantity of holding tank chemical into the toilet bowl.
Flush the toilet and allow at least two gallons (8 liters) of water to flow into the holding
3.
tank.
Waste (grey) holding tank preparation:
No special preparation is required, however, placing a small quantity of chemicals into this
tank, such as baking soda or an approved RV chemical, will reduce odors from food particles
in the system.
Cleaning & Maintenance:
The toilet should be cleaned regularly for maximum sanitation and operational efficiency.
Use only RV approved chemicals. Do not use chlorine (undiluted) or caustic chemicals,
such as laundry bleach or drain opening types, in the toilet system. These products damage
the seals in toilets and dump valves.
lack Tank Flush (Rinsing the Waste Tank)
B
The Tank Flush Inlet (also known as the No Fuss Flush), is the black inlet located on the
Utility Center Panel. This inlet is provided to assist in flushing out the black water tank.
The dump valve for the black water tank must be OPEN to use this feature.
When a water hose is connected, and when the water source is turned on, it sprays water
into the black water tank, which aids in moving out the waste and cleaning the interior of
the tank.
Maintenance Record
Table of Contents
p
S
lumbing
yStem
117
Advertisement
Table of Contents
