Table of Contents
Advertisement
1.
Connect a garden hose to the City Water inlet (do not use your fresh water hose to
sanitize the water lines or the tank)
2.
Set the colored valves to the SANITIZE setting:
(A) White handle pointing down
(B) Blue handle pointing down
(C) Black handle pointing right
(D) Red handle pointing left
(E) Green handle pointing right
The water heater is automatically bypassed on this setting.
3.
Place the other end of the hose in a container holding sanitizing solution.
4.
Turn the pump switch ON.
5.
Fresh water tank should begin drawing solution out of the container. To aid siphoning
place the container on a surface approximately 2 feet off the ground.
6.
Continue pumping until solution is drawn out of the container, or tank is at the desired
level.
7.
Turn the pump Switch OFF.
8.
Disconnect the garden hose from the City Water Fill inlet on the Utility Center.
"DRY CAMPING" (Pump supplies water from the fresh water tank):
1.
Make sure the fresh water tank has an adequate supply of water.
2.
Set the colored valves to the DRY CAMPING setting:
(A) White handle pointing right
(B) Blue handle pointing down
(C) Black handle pointing down
(D) Red handle pointing up
(E) Green handle pointing up
3.
Turn the pump switch ON.
Water should be available to all fixtures now.
4.
5.
Turn pump OFF when water is not being used.
NOTE:To fill the fresh water tank without a pressurized water
source, refer to SANITIZE (Siphon Fill) section above, and use
a container holding fresh potable water and a hose. Water will be
drawn into the tank by the pump. There is no gravity fill inlet on the
recreation vehicle.
Maintenance Record
Table of Contents
p
S
lumbing
yStem
95
Advertisement
Table of Contents
