Table of Contents
Advertisement
Rinse the system with fresh water:
13. Fill the fresh water tank full of clean (potable) water. (Select from 1 of 2 methods
below)
1.
Filling from a pressurized source: Set the valves to the POWER FILL TANK
setting. Connect a non-toxic drinking hose to the City Water Connection inlet.
Connect the other end of the hose to the pressurized water source. Turn on the
water source. When tank is full, turn off the water source, disconnect the hose
from the water source first, then disconnect from the Utility Panel.
Syphon filling from a water container: Set the valves to the SANITIZE setting.
2.
Insert a hose into the City Water Connection inlet, place other end of the hose in
a container of water. Turn pump ON to draw water into the tank. After the tank is
full, turn the pump OFF. Remove the hose and the container. (NOTE: to aid in
siphoning place the container on a surface approximately 2 feet off the ground.)
Drain valves must be off.
14. Power to water heater should be OFF. (both switches: Electric & LP GAS)
the fresh water tank is full:
Set the valves to the DRY CAMPING setting. Turn the pump ON to send water
through the lines.
15. Run water through all faucets (hot & cold, including outside shower) until chlorine
smell is gone. Turn faucets and outside shower off, turn pump OFF.
16. Then, drain the fresh water system again. (see Draining the Fresh Water System).
If the RV has the Full System Canister water filter, remove the canister, reinstall the
filter, and reattach the canister.
17. Refill the fresh water tank with fresh water again and when water heater is full of
water, turn the water heater power ON. Refer back to Step 13 above for instructions on
refilling the fresh water tank.
Lingering Chlorine Taste:
If a chlorine taste lingers in the water, flush the water system with a solution consisting of
one-quart vinegar to five gallons of clean water. Re-flush as necessary. This vinegar solution
may damage the water heater or the water filter, so both must be bypassed again before
performing this operation.
Follow the steps outlined in Draining the Fresh Water System with one exception, do not
drain the water heater. Do not remove the water heater drain plug.
Maintenance Record
Table of Contents
p
S
lumbing
yStem
When
107
Advertisement
Table of Contents
