Remote Start Auxiliary Output, 5-Pin - Clifford 1.2 Installation Manual

➤ Remote start auxiliary output, 5-pin

These signals are provided to drive additional optional relays.
1 PINK/WHITE
This wire is programmed as (-) 2nd ignition output from factory and can be
programmed (to drive a relay) as a (-) starter or an accessory output. (See
Feature programming Menu 3, feature 8.)
2 ORANGE
This wire works like the main accessory wire and can be used (with a relay) to
drive any additional accessory circuits in the vehicle.
3 VIOLET
This wire works like the starter wire and can be used (with a relay) to drive any
additional starter circuits in the vehicle.
4 PINK
This wire works like the ignition 1 wire and can be used (with a relay) to drive
any additional ignition circuits in the vehicle.
Note: Wires 1 - 4 on the remote start auxiliary outputs are wired to the (-) triggers
for the onboard remote start relays and are not diode isolated. If connecting
these wires directly to the vehicle you must place a 1-amp diode in line to pre-
vent feedback from the vehicle.
5 BLUE
This wire supplies an output as soon as the module begins the remote start pro-
cess. It can be used to activate a bypass module or power the key sense wire
in most vehicles to disarm the factory alarm without unlocking.
Note: Check vehicle information to verify if a bypass module is needed or if the
key sense wire is needed.
28
(-) 200mA FLEX RELAY CONTROL OUTPUT
(-) 200mA ACCESSORY OUTPUT
(-) 200mA STARTER OUTPUT
(-) 200mA IGNITION 1 OUTPUT
(-) 200mA STATUS OUTPUT
© 2008 Directed Electronics. All rights reserved.