Setting The Light Flash Polarity - Clifford 1.2 Installation Manual

Remote start keyless entry

Hide thumbs Also See for 1.2:

Table of Contents

Setting the light flash polarity

Light flash (+) / (-) polarity

The internal fuse is used to determine the light flash output. In the (+) position, the

onboard relay will output (+)12V on the WHITE wire, H1/11. In the (-) position,

the on-board relay will supply a (-) output When wiring into a multiplex circuit,

you can replace the fuse with a resistor (paying attention to the polarity setting).

(Refer to diagram on p.15, H1/4 White/ Brown wire description).

Note:

For parking light circuits that draw 10 amps or more, the internal jumper

must be switched to a (-) light flash output. P/N 8617 or a standard automotive

SPDT relay must be used on the H1/11 light flash output harness wire.

(Light Flash Fuse Jumper is under

access door - use needle nose pliers to

change fuse position)

Access door

Table of Contents

Show Quick Links

Table of Contents