Menu 3 - Remote Start - Clifford 1.2 Installation Manual

2-13 Aux 3 Linking None (1)
control (link to remote start Off. (5). When aux 3 is programmed to Smart Key
control, this wire outputs a 800ms pulse when the Remote Start is shut Off.
The system also monitors the door trigger input. When the door is opened dur-
ing the remote start runtime, the remote start shuts down and this wire outputs
the 800ms pulse.
Important:
and stops the car. It pulses the wire at the button to shut off the
car when the remote start is deactivated.

➤ Menu 3 - Remote start

3-1 Manual Transmission Mode:
is used for Automatic transmission mode. In the default setting the remote start
unit is programmed to look for a shutdown procedure to activate the remote
start.
Important:
manual transmission start to work.
3-2 Engine Checking Virtual Tach:
start monitors the cranking voltage of the vehicle and sets it as a reference point.
Fifteen seconds after the crank output sequence the remote start checks the volt-
age again to determine if the vehicle is running.
When set to voltage, (2) the unit cranks the starter for the programmed time and
then attempts to sense that the engine is running by detecting an increase in volt-
age. If programmed Off (3) the vehicle cranks for the programmed crank time.
The tach setting or voltage setting is not checked to verify that the car is running.
In the OFF setting, if the vehicle fails to start, the ignition stays on for the run dura-
tion. Using tach or either of the voltage settings is recommended.
When set to Tachometer, (4) the unit references the learned tach signal to disen-
gage the starter. In addition it will monitor the RPM and shut down if the engine
RPM is too high or too low.
Important:
programmed for the manual transmission mode to work.
© 2008 Directed Electronics. All rights reserved.
Lock (2) Unlock (3) Lock/Unlock (4) Smart key
This wire is connected to the pushbutton wire that start
This is the default setting. The two-honk setting
The optional door input has to be connected for
The tach wire must be connected and
(1) When set to "virtual tach" (1) the remote
51