Table of Contents
Advertisement
Neutral safety switch interface
Some vehicles do not have an electrical neutral safety switch. Instead, the ve-
hicle has a mechanical neutral safety switch that physically interrupts the starter
wire and is used when the vehicle is in any drive gear. If the remote start is
interfaced before this switch, it will provide protection from starting in gear.
However, some vehicles combine the column shift mechanism and the mechani-
cal neutral safety switch into one mechanical part.
:
Note
You must complete the remote start system installation before doing the
following test. Ensure that the remote start system is functioning normally. This
includes connecting to the brake as a shut-down.
➤ Testing the neutral safety switch
1.
Make sure there is adequate clearance to the front and rear of the
vehicle because it may move slightly.
2.
Make sure the hood is closed and there are no remote start shut-downs
active.
3.
Set the emergency brake.
4.
Turn the key to the "run" position, this will release the shifter.
5.
Place the car in drive (D).
6.
Place your foot directly over the brake pedal, but do not depress it. Be
ready to step on the brake if the starter engages.
7.
Activate the remote start system.
8.
If the starter engages, immediately depress the brake to shut the remote
start system down. If the starter does not engage, no additional safety
system is required.
If the starter engages and the vehicle is a General Motors product or
Dodge Dakota pickup, you can find an alternative shut-down method
to prevent the starter from engaging. Refer to www.directechs.com for
Document 1008 under the Resource tab. If the vehicle is not a General
Motors product or a Dodge Dakota pickup, please call Directed Electron-
ics Technical Support for an alternative shut-down method.
Do not return the vehicle to the customer until this feature is properly
installed!
30
© 2008 Directed Electronics. All rights reserved.
Hide quick links:
Advertisement
Table of Contents
