Table of Contents
Advertisement
3-10 Accessory State During Wait-To-Start On:
This feature will allow the se-
lection of the accessory output to be ON or OFF during wait-to-start. Use the
two-honk setting for OFF.
3-11 2nd Status Output: Normal:
This feature will allow selection of status
output or a rear defogger mode that turns on ten seconds after the vehicle has
started if the vehicle interior temperature is below 55 degrees F. The defogger
mode has two selections, latched, the LED will flash twice, or pulsed, the LED will
flash three times. Latched mode will only stay on for 10 minutes.
Note: When the defogger mode is on, the output will always be active and can
be turned on independently with the remote for a one-time activation. (See the
Remote control configuration table.)
3-12 Parking Lights Constant:
In the default setting, the parking lights (if con-
nected) will come on solid during the remote start runtime. In the two- flash setting
the parking lights will flash during the remote start runtime. In the OFF setting, the
parking lights will not come ON or flash, when the vehicle is remote started.
3-13 Anti-Grind On:
With the anti-grind On (default) the ground-when-armed
output will be active during remote start operation. This activates the optional
starter kill relay and prevents the customer from re-cranking the car with the key,
when doing key takeover. If accessories such as a voice module or window
module are added to the unit, it may be necessary to use the two-honk setting
to program this feature OFF.
3-14 Tach Mode Starter Release:
Normal:
Use the two-honk setting to in-
crease time by 15% of the original tach programmed time. The LED will flash
twice (2). To decrease by 15% of the original programmed time, the LED will
flash three (3) times.
3-15 Vehicle temperature auto report ON or OFF*.
The default setting is OFF.
When programmed ON the main unit will store the interior temperature of the
vehicle in its temporary memory. When the vehicle's interior temperature chang-
es 1 degree Celsius, the main unit automatically sends the interior temperature
message to the remote and the LED's light up accordingly to display the current
temperature.
*with 2-way upgrade
53
© 2008 Directed Electronics. All rights reserved.
Hide quick links:
Advertisement
Table of Contents
