Table of Contents
Advertisement
•
EXIT: Log out system menu.
4.4.4.8 Time Task
TIME TASK
START TIME
END TIME
TASK ACTION
PRESET
SCAN
TOUR
PATTERN
SAVE
BACK
EXIT
•
TIME TASK: Schedule task allows the speed dome to implement corresponding setup during the
specified time. There are two options: on/off. Please use the left/right button on the keyboard or in
the speed dome terminal menu to set.
•
START TIME: Here you can set the task begin time. Move the cursor to current item and then click
confirm button to set the time. Please use the up/down button to set the detailed value and then use
left/right button to go to the next setup item. After you completed the setup, please click confirm
button to exit start time setup and then move the cursor to the SAVE button to save current setup.
•
END TIME: Here you can set the task end time. Move the cursor to current item and then click
confirm button to set the time. Please use the up/down button to set the detail value and then use
left/right button to go to the next setup item. After you completed the setup, please click confirm
button to exit end time setup and then move the cursor to the SAVE button to save current setup.
•
TASK ACTION; The option here includes: none/tour/scan/preset/patter. Please use left/right button
to set.
•
PRESET: The speed dome will go to the selected preset at the specified time if you select the time
task as preset. The value ranges from 1 to 80.
•
SCAN: The speed dome will go to the selected scan at the specified time if you select the time task
as scan. The value ranges from 1 to 5.
•
TOUR: The speed dome will go to the selected preset at the specified time if you select the time task
as tour. The value ranges from 1 to 8.
•
PATTERN: The speed dome will go to the selected pattern at the specified time if you select the time
task as pattern. The value ranges from 1 to 5.
•
SAVE: After you completed the above setup, you need to move the cursor here and then click
confirm button to save current time setup.
•
BACK: Go back to the previous menu.
•
EXIT: Log out the system menu.
4.4.5
IR Light Setup
IR SENSITIVITY: 4(1-6)
SWITCH ZOOM: 6(2-10)
HEIGHT: 5(1-10)
IRLIGHT CTRL: ZOOM PRI (HEIGHT PRI, MANUAL)
NEAR LIGHT: 50(0-100, INTERVAL=5)
FAR LIGHT: 50(0-100, INTERVAL=5)
IRLIGHT COMP: 3(1-5)
Move the cursor to highlight IR LIGHT SETTING button and then click confirm button.
IR SENSITIVITY: Here you can enable the IR light sensitivity function.
：OFF
：06H 00M
: 10H 00M
: SCAN
: 001
: 001
: 001
: 001
27
Advertisement
Table of Contents
