Protocol, Baud Rate, Address Setup; Protocol And Baud Rate Setup - IC Realtime PTZ2300SIR User Manual

2 Protocol, Baud Rate, Address setup

Before you operate, you need to set protocol, baud rate and address. Otherwise you can not control
the product!

2.1 Protocol and Baud Rate Setup

Please configure the following settings before begin controlling dome:
Protocol
Baud rate
Address
Note: Please reboot the speed dome to get all the setups activated!
Open the lower dome, the interface is shown as below. See Figure 2-1.
SW2
Figure 2-1
SW2
Figure 2-2
6
SW1