Table of Contents
Advertisement
EXIT
The above diagram illustrates the overall structure of the speed dome setup menu.
Note:
ERR means current setup is invalid.
Please make sure all the cable connections are right.
4.2 Self-diagnosis System Information
After installation, please connect speed dome to power. The system goes on a self-diagnosis, and then it
pops up the above interface to show the system information.
If there is anything wrong during the self-diagnosis, system pops up error code.
The above interface disappears after speed dome received the first command (or the display time lasts for 4
minutes.)
ADDR: Here you can view dome address information. For example, 001-H, 1 is the address number, -H
is hard address mode. –S is software address mode.
Baud rate: Dome communication baud rate.
Parity: Communication parity bit format.
Protocol: Current communication protocol.
Model: Dome type.
Temperature: Current dome internal temperature.
Software: Dome PTZ software version.
4.3 Main Menu
You can open the IP dome menu via control keyboard, matrix, or speed dome control terminal.
SYSTEM INFORMATION：Dome self-diagnosis information, address information, system time setup,
set north direction, language, factory default setup, reboot and so on.
DISPLAY INFORMATION: Display dome preset title, azimuth display, time, direction, dome internal
temperature, dome external temperature information.
ADDR
：001-H
BAUD RATE
：9600
PARITY
：NONE
PROTOCOL
：PELCO-P
MODEL
：SD66XX
TEMP
: 032℃
SOFTWARE
：V1.04.3
BACK
EXIT
SYSTEM INFORMATION
DISPLAY SETTING
CAMERA SETTING
FUNCTION SETTING
IR LIGHT SETTING
ALARM SETTING
EXIT
15
Advertisement
Table of Contents
