Installation Planning - Bosch DICENTIS Instruction Manual

DICENTIS
4

Installation planning

Make sure you have all components for installing and connecting the DICENTIS Wireless
Conference System (see System overview, page 8).
–
–
1.
2.
3.
4.
5.
6.
Control capacity
–
–
Coverage area
–
802.11n specification
The DICENTIS Wireless Conference System network is based on the 802.11n specification for
WiFi technology. Devices that comply to the 802.11n specification operate in frequency bands
between 2.4000 and 2.4835 GHz and 5.180 and 5.700 GHz.
Notice!
Although the system operates on frequencies which are license free world wide, you must be
aware of country specific limitations and follow them.
Bosch Security Systems B.V.
Familiarize yourself with the products capabilities of the DICENTIS Wireless Conference
System (see System overview, page 8 and the paragraphs Control capacity and Coverage
area in this section.
Use only Bosch specified installation materials and tools (see Additional components, page
12).
Decide if, and which type of, cabling is required. See System overview, page 8.
Decide on how to power the Wireless Access Point (DCNM-WAP). See System overview,
page 8:
– Via the AC/DC power supply adapter (supplied with the DCNM-WAP). Or:
– Via Power over Ethernet (PoE). Or:
– Via Ethernet switch. Or:
– DCN multimedia (Audio) Powering Switch.
Provide a mains power supply connections nearby the equipment which requires mains
power supply.
Decide on how to power the other devices used in the system (i.e. Ethernet switch,
cameras etc.). See System overview, page 8:
– Via their own (mains) power supply provision. Or:
– Via Power over Ethernet (PoE), if possible.
Decide on how, and where, to install the Wireless Access Point (DCNM-WAP). See
Installation Wireless Access Point, page 13:
– Wall, ceiling or tripod floor stand.
– For a maximum WiFi coverage area, the DCNM-WAP can be placed on a central
location in the room.
Decide where, and how to place, the Wireless Devices (DCNM-WD and/or DCNM-WDE).
See Installation Wireless Devices and Accessories, page 19.
The Wireless Access Point (DCNM-WAP) can control a maximum number of 120 Wireless
Devices in the DICENTIS Wireless Conference System network.
Only one DCNM-WAP at the time can control the system.
All Wireless Devices need to be in the WiFi coverage area of the DCNM-WAP.
– The DCNM-WAP has a typical WiFi coverage area of 30 m by 30 m.
Installation Manual
Installation planning | en
2015.03 | V1.01 |
11