Bosch DICENTIS Instruction Manual page 20

20 en | Installation Wireless Devices and Accessories
3.
4.
5.
Connection, indicators and controls
The following table gives an overview of the Wireless Device items and functionality (Refer to
the numbers in the previous figure).
Connection and configuration of the Wireless Devices within the system is done via DCNM-
WAP. Refer to the software configuration manual of the DICENTIS Wireless Conference
System.
Item
1
2
3
4 + 5
6
7
8
9
10
11
12
13
14
15
16
17
18
2015.03 | V1.01 |
Install the Battery Pack (15) in each Wireless Device to be used. Refer to Battery Pack ,
page 23.
Attach the microphones to the Wireless Devices (11). Refer to Microphones, page 21.
Place the Wireless Devices in the coverage area of the Wireless Access Point (DCNM-
WAP). See Installation planning, page 11, if required.
Description
Near Field Communication (NFC) user identification (DCNM-WDE only). Used to
identify the (logon) participant with an NFC Tag.
4.3" capacitive touch screen (DCNM-WDE only).
Loudspeaker.
Combined button, depending on software configuration:
– chairperson priority button (4). Or,
– single-use device mute button (4). Or,
– dual-use device microphone request button (5).
LED (lightguide) microphone request button (5).
Microphone request button (single-use, chairperson or dual-use mode).
LED (lightguide) microphone request button (7).
Headphone volume control.
3.5 mm stereo jack for headphone.
Microphone (input) connector.
Red battery‑low LED indicator. The LED is flashing when the Battery Pack of the
Wireless Device is empty within 1 hour. Charging the Battery Pack is advised.
See Battery Pack , page 23.and Charger, page 25.
Yellow out‑of‑range LED indicator. The LED is on when the Wireless Device is not
(yet) connected with the Wireless Access Point (DCNM-WAP). Move the Wireless
Device within the coverage area of the DCNM-WAP. The LED is flashing when the
Wireless Device is trying to make a connection with the Wireless Access Point
(DCNM-WAP. See Installation planning, page 11.
(DCNM-WLIION) Battery Pack locking clip. See Battery Pack , page 23.
(DCNM-WLIION) Battery Pack. See Battery Pack , page 23.
De‑init button. When push (>2 seconds), the subscription between the Wireless
Device and Wireless Access Point is removed.
(DCNM-WLIION) Battery Pack capacity test button. See Battery Pack , page 23.
(DCNM-WLIION) Battery Pack capacity LED (5x) indicators. See Battery Pack ,
page 23.
Installation Manual
DICENTIS
Bosch Security Systems B.V.