Preparing The Dock For Use; Footprint - Honeywell Marathon Reference Manual

Preparing the Dock for Use

Note: Keep dirt and foreign objects out of the dock. Do not short circuit any of the charging terminals, as this action could
result in injury or property damage.
Honeywell recommends a stable, horizontal surface out of the way of:
inclement weather conditions,
l
extremely high concentrations of dust or wind blown debris,
l
accidental knocks, bumps or other shocks to the dock and items in the docking bays.
l
Leave enough space at cable connectors to ensure cables are protected from jostling, tugging or being disconnected by
l
passing objects.
Table Mounting
The dock can be mounted to a flat, stable surface using the mounting holes at the base of the extended battery charging bay
(mounting hardware is not supplied by Honeywell).
Periodically check the dock connection and table connection for stability. Re-tighten as necessary.

Footprint

Measurements are not to scale. Mounting holes require size #10 / 4mm screws/washers or bolts/nuts (not supplied by
Honeywell).
NOT TO SCALE
1. Back of desktop dock
2. Front of desktop dock
3. 9 in / 22.8 cm
4. 6.75 in / 17.1 cm
5. 7.5 in / 19.0 cm
6. 4.25 in /10.7 cm
7. 2.5 in / 6.3 in
8. Desktop mounting holes
2-3