Installation Stacking - Samsung SDC18809 User Manual

Condensing dryer
Hide thumbs Also See for SDC18809:
Table of Contents

Advertisement

INSTALLATION STACKING

In case of purchasing the additional stacking kit, contact our Samsung service center or local
distributers. [Part no. SK-DH / SK-DA]
1. Carefully lay the dryer on its side. Use the packing material
so you don't scratch the finish on the dryer.
2. Install rubber pads to dryer base.
• Locate the 4 rubber pads in the parts package. Insert
• Purchase the stacking-kit package additionally.
3. Set the dryer upright.
The stacking kit can only be installed for Samsung family products.
CAUTION
4. Install bracket to dryer.
• Remove washer top cap screw from the rear left.
• Repeat the above step with the right side.
5. Install dryer and bracket on washer
• Lift the dryer on top of the washer. Protect the washer
WARNING
• Align the holes in the bracket with the holes in the back of the dryer.Using a Phillips
• Tighten the washer bracket screws ; then tighten all stacking kit screws.
6. Finalise the installation
• Refer to the washer Installation Instructions to
WARNING
• Refer to the dryer Installation Instructions to complete
• Carefully slide or walk the stacked washer and dryer
SDC18809X-02805K-05_EN.indd Sec3:15
SDC18809X-02805K-05_EN.indd Sec3:15
the rubber pads into the holes at the bottom of the
levelling legs.
Align left bracket holes with top cap screw hole on
rear left of the unit and replace screw.
Leave screw loose so dryer hole alignment will be
easier.
control panel with cardboard or other protection. Be
sure to lift the dryer high enough to clear the washer
control panel.
Personal Injury. More than two people are
recommended to lift the dryer into position because
of its weight and size. Failure to do so could result in
injury.
screwdriver, attach the M4x12 tapping screws.
complete the washer installation.
the dryer installation.
into place. Use felt pads or other sliding device to
assist moving and to protect flooring.
Do not push on the dryer once installed to top of the
washer. Pushing on the dryer may result in pinched fingers.
Bracket-Stacking
Screw
Dryer
Washer
installing your dryer _15
2013-07-04
2013-07-04
2:24:31
2:24:31

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sdc1a809Sdc3c801Sdc3k801Sdc3c803

Table of Contents