My Cycle; Delay End; Interior Lamp - Samsung SDC18809 User Manual

MY CYCLE

Lets you activate your customised cycle that includes Dryness, drying temperature and time option.
By pushing the My Cycle button, you activate the settings used during the previous My Cycle mode.
(Default : Normal Cycle)
If My Cycle mode is activated, the My Cycle indicator will be lit.
You can select all options in My Cycle mode as follows.
1. Select cycle using the Cycle Selector dial.
2. After cycle selection, set each option.
Each cycle has certain default options that are automatically set.
To see these default options, go to page 33.
3. Then, you can start My Cycle by pushing the Start/Pause button in My Cycle mode. The cycle and
options you select will be displayed the next time you choose My Cycle.
You can change the My Cycle settings by repeating the same process above.
The last used setting will be displayed the next time you choose My Cycle.

DELAY END

You can set the dryer to finish your drying cycle automatically at a later time, choosing a delay of between 4
to 19 hours (in 1 hour increments). The hour displayed indicates the time at which the dry will be finished.
1. Manually or automatically set your drying machine according to the type of laundry you are drying.
2. Press the Delay End button repeatedly until the required delay time is set. If the delay time is set, the
"Delay End" function becomes ON state.
3. Press the Start/Pause button. The "Delay End
down until it reaches the set time.
4. To cancel a Delay End function, press the Power button and then turn the dryer on again.

INTERIOR LAMP

Lights the dryer drum while the dryer is running.
Setting & releasing
If you want to set or release the Interior Lamp, press both the Interior Lamp buttons
simultaneously.
This can be set as long as the power cord is connected to the wall outlet. If you do not turn
the Drum Light off within 5 minutes of turning it on, it is automatically turned off.
SDC18809X-02805K-05_EN.indd Sec5:21 SDC18809X-02805K-05_EN.indd Sec5:21
" indicator will blink and the clock will begin counting
operating Instructions, tips _21
2013-07-04 2013-07-04 2:24:38 2:24:38