Installation Stacking - Samsung DV9 Series User Manual

installing your dryer

INSTALLATION STACKING

In case of purchasing the additional stacking kit, contact our Samsung service center or local
distributers. [Part no. SK-DH / SK-DA / SKK-DF]
The stacking kit diff ers depending on the model.
Only use the product in 1 hour after installing the stacking kit by tilting the product so that the product
can run after the oil in the compressor becomes stable.
1. Carefully lay the dryer on its side. Use the packing material so
you don't scratch the fi nish on the dryer.
2. Install rubber pads to dryer base.
• Locate the 4 rubber pads in the parts package. Insert the
rubber pads into the holes at the bottom of the levelling legs.
• Purchase the stacking-kit package additionally.
3. Set the dryer upright.
The stacking kit can only be installed for Samsung family products.
CAUTION
4. Install bracket to dryer.
• Remove washer top cap screw from the rear left. Align left
bracket holes with top cap screw hole on rear left of the unit
and replace screw.
Leave screw loose so dryer hole alignment will be easier.
• Repeat the above step with the right side.
5. Install dryer and bracket on washer
• Lift the dryer on top of the washer. Protect the washer
control panel with cardboard or other protection. Be sure to
WARNING
lift the dryer high enough to clear the washer control panel.
Personal Injury. More than two people are recommended
to lift the dryer into position because of its weight and size.
Failure to do so could result in injury.
• Align the holes in the bracket with the holes in the back of the dryer.Using a Phillips
screwdriver, attach the M4x12 tapping screws.
• Tighten the washer bracket screws ; then tighten all stacking kit screws.
6. Finalise the installation
• Refer to the washer Installation Instructions to complete
the washer installation.
WARNING
• Refer to the dryer Installation Instructions to complete the
dryer installation.
• Carefully slide or walk the stacked washer and dryer
into place. Use felt pads or other sliding device to assist
moving and to protect fl ooring.
Do not push on the dryer once installed to top of the
washer. Pushing on the dryer may result in pinched fi ngers.
DV90F5E6HGW-03297J-07_EN_160217.indd Sec3:16 DV90F5E6HGW-03297J-07_EN_160217.indd Sec3:16
English - 16
Bracket-Stacking
Screw
Dryer
Washer
2016-02-17 2016-02-17 7:32:13 7:32:13