Table of Contents
Advertisement
Display of the Power Save Setting
(POWER SAVE)
The power save setting of the transmitter is displayed.
Display of the Transmission Power
Setting
(RF POWER)
The transmission power setting of the transmitter from
which transmission is currently being received is
displayed.
Display of Audio Input Level
LEVEL)
The audio input level setting of the transmitter from which
transmission is currently being received is displayed.
Display of the Attenuator
The attenuator setting of the transmitter is displayed.
Display of the Low-cut Filter Setting
(LCF)
The low-cut filter setting of the transmitter is displayed.
Display of the +48 V Power Setting
(+48V)
The +48 V power setting of the transmitter is displayed.
Display of Accumulated Transmitter
Use Time
(TIME)
The accumulated use time of the transmitter is displayed.
Display of Internal Signal Generation
(INTERNAL SG)
Displays whether the transmitter's internal signal is being
generated.
POWER Switch Lock
The POWER switch lock function setting of the
transmitter is displayed.
POWER Switch Status
The POWER switch status of the transmitter is displayed.
30
RF REMOTE Menu
(INPUT
(ATT)
(PWR SW LOCK)
(PWR SW STATE)
RF REMOTE Menu
For details on menu operation, see "Basic Menu
Operations" on page 27.
This receiver is equipped with the wireless remote control
function that can be used to set the parameters (low-cut
filter, attenuation operation, power save mode, etc.) of the
transmitter through the TRANSMITTER menu. This
function makes it easier to operate and manage the
microphone system while in the field.
This wireless remote control is 2.4 GHz IEEE802.15.4
compliant and has no effect on the RF band of digital
wireless audio.
This function is activated when pairing is established
between the transmitter and the receiver using the RF
REMOTE menu.
Note
If the software version is not suitable for use with this
receiver, the wireless remote control function may not
function. A software update may be necessary to enable
proper functioning. For details on software updates,
contact your Sony service representative.
For details on transmitter software versions that are
compatible with this receiver, see "Transmitter software
version" on page 41.
Using the Cross Remote
This function must be set to allow the wireless remote
control function to be used between the transmitter and
receiver.
OFF: Stops the wireless remote control function.
ON: Starts the wireless remote control function with the
previously paired receiver.
Pairing With a Transmitter
Pairing links the receiver with the transmitter which the
wireless remote control function is to be used.
Set pairing configurations as follows:
1
In the RF REMOTE menu, rotate the jog dial to select
PAIRING, and then press the dial.
A message "START PAIRING?" appears.
2
Set the transmitter to be controlled to pairing mode.
(RF REMOTE)
(PAIRING)
Advertisement
Table of Contents
