Scanning starts. When a Sony digital wireless
frequency is detected, scanning stops and the
frequency is displayed.
If you select NO in this step
The scanning function is cancelled.
If you decide to use that channel, rotate the jog dial to
select SET, and then press the dial.
To search for another frequency
Rotate the jog dial to select CONTINUE, and then
press the dial.
If a Sony digital wireless frequency within the group is not
found by the second try, scanning is cancelled.
Using the Clear Channel Scan
This function searches for a channel that is not being used
by another wireless device or by a TV station. This
function makes it easy to find an available channel to allow
the wireless microphone to be used without interference.
The function searches for empty channels among the
registered channels within the channel group selected by
the GP/CH selection function, and lists the detected
channels in the order with less interference.
Press the RECEIVER button to select the RECEIVER
Rotate the jog dial to move the cursor to CLEAR CH
SCAN indication, and then press the dial.
A message "START SCAN?" appears.
Rotate the jog dial to select YES, and then press the
Scanning starts. Empty channels within the specified
channel group (GP) are searched. When scanning
finishes, detected empty channels are listed in the
order with less interference.
Rotate the jog dial to select the channel that you want
to use, and then press the dial.
When the Cross Remote (see page 30) is
When the jog dial is pressed in Step 4 above, a message
confirming to apply the selected channel to the transmitter
that is paired with the DWR-R02D appears.
When you rotate the jog dial and select OK and press the
dial, the selected channel is applied to the transmitter.
• If an empty channel within the group is not found by the
second try, scanning is cancelled.
• If the receiving channel (CH) configured on the receiver
is a channel for which use with the wireless remote
control function is restricted on the transmitter side, the
UNMATCH screen appears.
In such cases, change the receiving channel on the
receiver. If you want to use the restricted channel, set
REMOTE to OFF in the transmitter's menu to release
the channel restriction, and manually configure the
Setting the Receiving Channel