Channel Selection; Call Procedure - Icom iC-F3062T Instruction Manual

3
BASIC OPERATION

Channel selection

■
Several types of channel selections are available. Methods
may differ according to your system set up.
NON-ZONE TYPE:
Push [CH Up] or [CH Down], or rotate [ROTARY SELEC-
TOR]* to select the desired operating channel, in sequence;
or, push one of [MR-CH 1] to [MR-CH 4] keys to select a
channel directly.
• Up to 16 pre-programmed channels can be selected via [ROTARY
SELECTOR].*
ZONE TYPE:
Push [Zone], then push [CH Up] or [CH Down] or rotate [RO-
TARY SELECTOR]* to select the desired zone.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turn-
ing power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call.
*Depending on the pre-setting.
12

Call procedure

■
When your system employs tone signaling (excluding CTC-
SS and DTCS), the call procedure may be necessary prior
to voice transmission. The tone signaling employed may be
a selective calling system which allows you to call specific
station(s) only and prevent unwanted stations from contact-
ing you.
Select the desired TX code channel or 2/5-tone code ac-
q
cording to your System Operator's instructions.
• This may not be necessary depending on programming.
• Refer to page 14 or 15 for selection.
Push the call key (assigned to one of the dealer program-
w
mable keys: [Emer], [Side1], [Side2], [Side3], [P0], [P1],
[P2] and [P3]) or [PTT].
After transmitting a 2/5-tone code, the remainder of your
e
communication can be carried out in the normal fashion.
Selective calling Non-selective calling