Lotus 2004 Eleven Service Notes page 324

Lotus Service Notes
RHD Shown
(LHD symmetrically
opposite)
Wiper linkage
in full travel
position
6. Re-assemble in the reverse order to removal, torque tightening the bracket bolts to 20 Nm.
MP.9 - HARNESS ROUTING
The main harness runs from the main fusebox/relay station at the passenger side of the front services
compartment, and divides into three branches; one running forwards across the front of the chassis well to feed
the interior fan motor, heater/a.c. functions, radiator fans and ABS controller, and then round the front of the
crash structure to supply the horn and front lights. A second branch connects to the radiator fans/a.c. control
module mounted on the passenger side wheelarch liner. The third brance runs rearwards through the scuttle
where it divides again to run across the dash top, picking up on the positive post, and supplying the instrument
pack and switchgear. The harness then runs along the cockpit centre tunnel to the rear of the cabin, over the
top of the fuel tank bay, and through a grommet at the left hand rear corner of the cabin.
At the left hand front corner of the engine bay, one branch continues rearwards through a rear clamshell
grommet to connect with the rear lighting harness routed inside the clamshell. Another branch runs across the
engine bay/cabin bulkhead to the multi-function relay module and engine ECU. The engine harness connects
to the ECU on the bulkhead.
Front section fixed
to crash structure
Fusebox &
rad. fan/a.c.
module
Positive
post
Routed along dash top
Routed along
centre tunnel
Engine harness
Engine ECU
Section MP
m209
Wheel speed
sensor
Rear
harness
pl1701mt
Page 21