Lotus 2004 Eleven Service Notes page 336

Lotus Service Notes
Tachometer
High rpm
tell tales
LCD panel
- The engine is not protected from overspeeding caused by erroneous or premature downchanging. Such
misuse could result in catastrophic failure, not covered by the vehicle warranty.
SCHEDULED SERVICE TELL TALE (IF FITTED)
Under normal usage conditions, a routine maintenance service should be performed at the first occurring
of 9,000 miles (15,000 km) or 12 months from the previous service (USA; 7,500 miles/6 months). The approved
service period extends to 500 miles before/after or one month before/after the stipulated distance/time.
As a driver aid to distance servicing, an amber wrench icon in the face of the speedometer will flash for 10
seconds following each ignition turn on, when within 500 miles (800 km) of the service period, allowing plenty
of time for booking arrangements to be made. Once the service period is reached, the tell tale will remain
constantly lit with ignition until reset by your dealer.
Note that this feature is provided only as a secondary aid, and uses only distance criteria, and not the
time factors which may predominate. It is the owner's responsibility to ensure that servicing is carried out at
the prescribed intervals..
TRIP DISTANCE/DIGITAL SPEED DISPLAY/TIME CLOCK
The top left portion of the LCD panel may be cycled through the following displays:
- Trip distance (in same units as analogue speedometer).
- Digital road speed in alternative units to those indicated by the analogue instrument (either mph or
km/h).
- Digital time clock (if fitted - this feature will not be available initially).
To cycle, one at a time, through these three displays, briefly press the small button on the right hand side
of the steering column shroud. (Note that this button also adjusts the brightness of the instrument and HVAC
panel illumination if held pressed when road speed is selected).
Trip distance: Units displayed are miles, and range from 000.0 to 999.9. To reset to zero; when the trip function
is displayed, press the button on the column shroud for longer than 1 second.
Time Clock Setting: To adjust the 24 hour time clock (if fitted);
- when the time function is displayed, press the button on the column shroud for longer than 1 second. The
hour display will then flash.
- Repeated brief presses of the button will increment the hour figure. Pressing the button for longer then 1
Service tell tale
Traction control
tell tale
Speedometer
Low tyre pressure
tell tale
Section MP
Security tell tale
ohs127b
Page 33