Lotus 2004 Eleven Service Notes page 308

Lotus Service Notes
ii) Enter the PIN: Immediately the tell tale goes out, switch ON the ignition and count the number of
security tell tale flashes until equal to the first number of the PIN, then turn the ignition OFF, then back ON
again.
iii) Repeat operation (ii) for the remaining 3 digits of the PIN, remembering to turn the ignition OFF and
back ON after each code number.
Note: If at any time a mistake is made when entering the PIN, turn the ignition OFF for 10 seconds and
re-commence entering the PIN.
5. After finishing step (4) with the ignition on, within 7 seconds, press once the large button of each transmit-
ter fob.
6. Turn off the ignition.
7. Test operation of each transmitter fob.
Location of Components
The alarm system components are located as follows:
- Electronic Controller: Mounted on top of the scuttle beam at LH extreme end. Accessible after removal
of fascia top.
- Siren Unit: Mounted on front of radiator duct LH extension, beneath LHF turn lamp. Accessible only after
removal of front clamshell.
- Immobiliser Module: Mounted on left hand end of cabin rear bulkhead. Accessible after removal of rear
bulkhead trim panel.
- Microwave Sensor: Mounted centrally on cabin rear bulkhead, beneath trim panel.
- Engine Lid Sensor: Mounted on luggage compartment bulkhead, alongside latch.
- Front Access Panel Sensors: Mounted on brackets fixed to topshell at outboard edge of aperture.
Front access cover sensor
Siren unit
Identification of alarm controller
Note that earlier Elise variants have used versions of the alarm controller with and without CDL function-
ality. For Elise 111R and Exige models with CDL, the controller should be printed with the identification 8185
4C8170AIB.
Electronic controller
Door switch
Section MP
Microwave sensor
Engine lid sensor
Immobiliser module
m240a
Page 5