Lotus 2004 Eleven Service Notes page 334

Lotus Service Notes
If, at any stage of the process, a number is entered incorrectly, the system will immediately revert to the
start, so that the whole PIN must be re-entered.
Programming Additional Transmitters
A maximum of 6 transmitters may be programmed to the car, any thereafter overwriting the first to have
been programmed.
- With the engine immobilised (tell tale flashes briefly once per second), turn on the ignition.
- Enter the PIN as detailed above, followed by the additional two digits 1, 1.
- The tell tale will flash rapidly for one second, then turn off.
- Within 8 seconds, press any button on the transmitter to be programmed. The tell tale will then pulse
rapidly and the siren will beep.
- Within 10 seconds press any button on the next transmitter to be programmed (if applicable), and repeat
this process for all remaining transmitters.
- When all transmitters have been programmed, wait for 10 seconds, or turn off the ignition.
To disable a lost or stolen transmitter from the system, use the above procedure to programme 6 trans-
mitters, if necessary repeatedly reprogramming the same transmitter if less than 6 programmed transmitters
are to be used.
Trigger Report Back and Feature Selection
A facility is provided to identify the source of an alarm triggering event (trigger report back), as well as
allowing certain features of the system to be selected or de-selected. The same procedure described above
to input a PIN is used, but in this case to input the programming code '123'; the tell tale will then flash rapidly
for 1 second, then remain lit. Commencing within 10 seconds, continue this procedure to input the two digits
of the feature code, after which the tell tale will flash rapidly for 1 second then beep once or twice to indicate
the new status of that feature; one for 'ON', twice for 'OFF'. Selection will alternate each time that feature code
is entered. Note that within 10 seconds, a second feature code (or repeat) may be selected from this point by
entering only the 2-digit code. To exit programme mode, simply wait for 10 seconds.
Feature
Revert to defaults
Trigger report back
Unlock with ignition
Lock with ignition
Selective door unlock
Audible tones*
Lock with auto re-arm
Door open audible warning 123 88
* When selected, a single beep will sound when the alarm is armed, and a double beep when disarmed. To
silence for a single activation, press briefly the transmitter auxiliary (3rd) button prior to pressing the arm or
disarm button.
Trigger report back: After the code 12311 has been entered, the tell tale flashes out a code(s) to indicate the
source of the alarm trigger:
No. of flashes Triggering sensor
1 Microwave movement sensor
2 Door, bonnet or boot lid
3 Ignition energisation
4 Manual siren activation
Quick Test
To facilitate testing of the alarm system, the unit can be placed into a 'Quick Test' mode by arming the
alarm with one transmitter key, and disarming with another. In this mode, the system will shorten the siren time
to 2 seconds, the immobiliser arm time to 5 seconds, and the settling time to zero. To exit this mode, simply
wait for 2 minutes without any further inputs.
Note that in Quick Test mode, any movement detected by the microwave sensor will trigger only the tell
tale and not the siren. The 2 minute timer will not be extended.
Code Default
123 00
123 11 see below
123 33 OFF
123 34 OFF
123 41 ON
123 61 OFF
123 87 ON
ON
Section MP
1 Beep 2 Beeps
ON OFF
ON OFF
ON OFF
ON OFF
ON OFF
ON OFF
Page 31