Lotus 2004 Eleven Service Notes page 267

Lotus Service Notes
5. Release the pedal return springs and remove the stop lamp switch.
6. From above, release the six M6 screws securing the pedal shaft mounting bracket to the top of the pedal
box, and the single screw in the front face of the pedal box. Withdraw the pedal shaft assembly from
inside the pedal box.
7. Remove the three M5 screws securing the pedal shaft to its mounting bracket, and disassemble the
pedals from the shaft taking careful note of spacers and washers.
8. On re-assembly, note that the pivot bushes of the brake pedal and relay lever should be lubricated with
Syntheso GLK1, or equivalent. Check pedal pushrod and stop switch operation as detailed above.
Pedal shaft mounting
plate fixing
Pedal
shaft
mounting
plate
Pedal pivot
bush
Clutch
pedal
trunnion
Pedal shaft
Page 22
Pedal box
Alloy clutch
pedal
Throttle
cable
Downstop
Brake pedal
steel relay lever
Section JJ
Throttle cable
abutment on
scuttle
Pedal
footpad
pl1401mt
Throttle cable
abutment on
engine plenum