Lotus 2004 Eleven Service Notes page 240

Lotus Service Notes
To Remove Upper Steering Column Assembly
WARNING: On cars so equipped, the driver's airbag is housed in the hub of the steering wheel. Precau-
tions need to be taken for personal safety when working with airbags and associated componentry. Do
not attempt to remove the airbag, steering wheel or column without first referring to section WD.
1. Disconnect the battery, and remove the column shrouds (see sub-section HG.2).
2. Disconnect the column lever switches, or release the retaining pawls and slide the switches out of the
carrier. Disconnect the horn contact pin. On airbag equipped cars, refer to section WD and unplug the
yellow airbag harness connector.
3. To disconnect the ignition switch: prise open the terminal cover, and use a small screwdriver to release
the retaining barb located between the white and yellow cables. Withdraw the connector.
4. If necessary, remove the steering lock/ignition key barrel: Turn the key to position 'I', depress the spring
pin accessible via a hole in the column switch carrier, and withdraw the lock barrel.
5. If necessary, remove the ignition switch: First remove the steering lock/ignition key barrel (see above).
Remove the retaining grub screw and withdraw the switch.
6. If necessary, remove the steering lock assembly: Remove the spline head screw securing the column
switch carrier, and drill or chisel out the two shear head bolts fixing the lock assembly to the column.
7. Remove the pinch bolt securing
the upper universal joint to the
intermediate column.
8. On non-airbag cars, remove the
two fixings for the instrument pack
mounting brackets, and remove
the instrument pack and cowl as-
sembly after unplugging the single
harness connector.
On airbag equipped cars, withdraw
the instrument surround and cowl
straight rearwards from the dash
panel to release the spring clips.
Remove four screws to release
the instrument pack mounting
bracket from the dash and unplug
the two harness connectors
9. Release the two bolts securing the
upper column clamp to the dash
brackets, and remove the switch
pack.
10. From the access provided by
the removal of the switch pack,
release the upper column single
lower fixing and withdraw the
column assembly from the scuttle
and off the intermediate steering
column.
Page 8
Non-airbag type shown
Instrument cowl
Instrument
pack
Section HG
Instrument
& cowl
mounting
bracket
b259a