Calibrating Paired Device; Calibrate By Running Or Walking - Oregon Scientific SE836 User Manual

CALIBRATING PAIRED DEVICE

IMPORTANT
To ensure accurate calculations with your
exercise, you should first calibrate the watch with the paired
device(s).
The watch will not show "CAL DEVICE" if no device is
paired.
You can calibrate by running or walking. You can also
input your Run or Walk parameter, which is your personal
calibration ID after you have successfully calibrated by
running or walking.
If you want to calibrate the device immediately after pairing,
go directly to step 4. Otherwise, start from the beginning.

CALIBRATE BY RUNNING OR WALKING

. Press MODE repeatedly to select
2. Press SET.
3. Press ST/LAP/+ repeatedly to select "CAL DEVICE".
4. Press SET.
5. Press ST/LAP/+ to select "CAL BY RUN" or "CAL
BY WALK". You should calibrate both by running and
walking, one after another.
6. Press SET to confirm selection.
7. Set distance by pressing ST / LAP / + or - / SP. Press
SET to confirm. Use the same distance when calibrating
by running and walking.
.
8. The watch will conduct a device search first, as indicated
by flashing
9. When the screen below is displayed, press SET to start
calibration.
NOTE
•
you walk and run on a standard configured track
(preferably an athletics track)
0
. Wait until stops flashing.
or
Make sure: